Chamsys MagicQ User Manual Uživatelský manuál stáhnout pdf (Strana 249)

MagicQ User Manual 220 / 355

28.8.1 Selecting which console controls which channels

MagicQ enables several different ways of selecting which channels are controlled from which console on the network – selected

channels, active channels, groups of channels, universes and zones. MagicQ defaults to the show master having control of all the

channels.

Slaves request control of channels using the Setup, View DMX I/O, Multi Prog Select soft button.

None The Slave does not control any channels.

One Head The Slave controls the ﬁrst selected head only. If Next

Head is used to sub select heads then the ﬁrst sub selected

head is controlled.

Selected The Slave controls the currently selected heads. When no

heads are selected, none are controlled.

Active The Slave controls all channels that are active in the

programmer.

Last Active The Master and Slave both control channels – the last one

to change a channel in the programmer controls the

channel.

Group The Slave controls the group that was selected when this

option was chosen.

Zones The Slave controls selected zones (as set up in DMX I/O)

Universes The Slave controls selected universes

All The Slave controls all channels

When multiple slaves are in use then different slaves can control different channels on the lighting rig. If the same channel is

requested by multiple slaves then the latest selection will take precedence. The show slave shows the multiple control method in

the status bar – e.g. for selected heads it shows “CC-Sel”.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 383 384

Žádné komentáře

Chamsys MagicQ User Manual Uživatelský manuál Strana 249